[Edit]
[General]
[Baseline to Apply]
[Credentials]
[General]
[IP/DNS]
[Description]
[Type]
[Windows]
[Linux]
[HP-UX]
[VMware Host]
[Onboard Administrator]
[Superdome 2 Onboard Administrator]
[Moonshot]
[HP SAS B/L Interconnect Switch]
[Fibre Channel Switch]
[iLO]
[Virtual Connect]
[Unknown]
[Auto Add Associated Nodes]
[If active update process is detected on the remote node, HPSUM should]
[Leave the update running and bypass the node]
[Stop any currently running update process on the node and replace it with updates from this session]
[Baseline to Apply]
[Optional. Select an already added and inventoried baseline and/or additional package to apply to this node. If not added now, a baseline or additional package must be specified when Inventory is started on the node.]
[Current Baseline selected]
[Baseline]
[Additional Package selected]
[Additional Packages]
[Credentials]
[Enter Administrator Credentials]
[Enter SSH key Credentials]
[Username]
[Password]
[Username]
[Required]
[Required]
[Passphrase]
[Required only if a passphrase is required for the private key file]
[iLO CM Administrator Credentials]
[Username]
[Password]
[Switch Credentials]
[Username]
[Password]
[Enable Password]
[Credentials are the same on both switches]
[Switch B Credentials]
[Username]
[Password]
[Enable Password]
[VCenterCredentials]
[Use VCenter]
[IP/DNS]
[Required]
[Username]
[Required]
[Password]
[Required]
[Access Level]
[None]
[Use sudo with credentials entered above]
[Enter Root user credentials to update components]
[Username]
[Password]
[Use Credentials Above]
[Enter Administrator Credentials]
[Username]
[Password]
[Virtual Connect Options]
[VC Activation options]
[Activation Order]
[VC Enet Modules Activation Order]
Odd-Even
Serial
Parallel
[VC FC Modules Activation Order]
Odd-Even
Serial
Parallel
[Activation Delay]
[VC Enet Modules Activation Delay]
[VC FC Modules Activation Delay]
[Installation Options]
[Reboot Options]
[Reboot System after installation]
[Never]
[If Needed]
[Always]
[Reboot Delay (Seconds): ]
[Enter reboot message]
[Reboot at user request after deploy]
[Reboot node to activate firmware]
[No]
[Yes]
[Reboot is not required. The node is powered off]
[Installation Options]
[Installation Options]
[Firmware and Software]
[Firmware]
[Software]
[Downgrade Firmware]
[Downgrade Software]
[Downgrade Both]
[Rewrite Firmware]
[Rewrite Software]
[Rewrite Both]
[Downgrade and Rewrite Firmware]
[Downgrade and Rewrite Software]
[Downgrade and Rewrite Both]