﻿1 GetAttributes

     ----------------------------------------------------------------------

   getattributesを使用すると、選択したノードの属性のいずれかを表示できます。
   属性はSetAttributesコマンドを使用して変更できます。

  1.1 構文

   hpsum getattributes [--nodes [nodelist]] [--session]

  1.2 パラメーター

   getattributesコマンドには次のオプションがあります。

   +------------------------------------------------------------------------+
   | パラメーター         | 説明                                            |
   |----------------------+-------------------------------------------------|
   | HPSUM                | HP SUMスクリプトがこのアクションを開始します。  |
   |----------------------+-------------------------------------------------|
   | getattributes        | 選択したノードの属性を表示するコマンド。        |
   |                      |                                                 |
   |----------------------+-------------------------------------------------|
   |                      | 属性を取得するノードのリスト。ノードリストを指定|
   | --nodes [<nodelist>] | しない場合、セッションのすべてのノードが表示され|
   |                      | ます。                                          |
   |----------------------+-------------------------------------------------|
   | --session            | HP SUMセッションで使用可能な属性を一覧表示しま  |
   |                      | す。                                            |
   +------------------------------------------------------------------------+

  1.3 リターンコード

   +------------------------------------------------------------------------+
   | リターンコード         | Windows | Linux | テキスト                    |
   |------------------------+---------+-------+-----------------------------|
   | SUCCESS_NO_REBOOT      | 0       | 0     | The command was successful. |
   |                        |         |       | （コマンドが成功しました。）|
   |------------------------+---------+-------+-----------------------------|
   | FAILURE_GENERAL        | -1      | 255   | A general failure occurred. |
   |                        |         |       | （一般障害が発生しました。）|
   |                        |         |       | For details, see the logs.  |
   |                        |         |       | （詳細は、ログを参照してくだ|
   |                        |         |       | さい。）                    |
   |------------------------+---------+-------+-----------------------------|
   |                        |         |       | A bad input parameter was   |
   | FAILURE_BAD_PARM       | -2      | 254   | encountered.（不正な入力パラ|
   |                        |         |       | メーターが検出されました。）|
   |                        |         |       | For details, see the logs.  |
   |                        |         |       | （詳細は、ログを参照してくだ|
   |                        |         |       | さい。）                    |
   |------------------------+---------+-------+-----------------------------|
   | FAILURE_COMMAND_FAILED | -4      | 252   | The command failed.         |
   |                        |         |       | （コマンドが失敗しました。）|
   |                        |         |       | For details, see the logs.  |
   |                        |         |       | （詳細は、ログを参照してくだ|
   |                        |         |       | さい。）                    |
   +------------------------------------------------------------------------+

  1.4 例

    Windowsのサンプルのコマンドライン

   C:\> hpsum getattributes /nodes localhost

    Linux/HP-UXのサンプルのコマンドライン

   $ hpsum getattributes --nodes localhost
