[Add Node]
[Nodes]
[Select operation]
[Add a single node by IP/DNS name]
[Find nodes on network]
[IP/DNS]
[Description]
[Node type]
[Select Type]
[Windows]
[Linux]
[VMware Host]
[Onboard Administrator]
[Superdome X Onboard Administrator]
[HP SAS B/L Interconnect Switch]
[Fibre Channel Switch]
[iLO]
[Moonshot]
[Virtual Connect]
[Unknown]
[Automatically Add Associated Nodes]
[If active update process is detected on the remote node, SUM should]
[Leave the update running and bypass the node]
[Stop any currently running update process on the node and replace it with updates from this session]
[Prerequisites installation option]
[Install iLO Channel Interface Driver if not already installed]
[if CHIF driver is not already installed, inventory and recommended updates may be incomplete on Gen9 and older generation servers. Gen10 and above servers require CHIF driver to be installed]
[Baseline to Apply]
[Optional. Select an already added and inventoried baseline and/or additional package to apply to this node. If not added now, a baseline or additional package must be specified when Inventory is started on the node.]
[Baseline]
[Additional Packages]
[Group]
[Group Description]
[Assign to]
[Credentials]
[Use Current Credentials (requires existing trust relationship with the target)]
[Enter Administrator Credentials]
[Enter SSH key credentials]
[Username]
[Required]
[Password]
[Required]
[Username]
[Required]
[Required]
[Passphrase]
[Required only if a passphrase is required for the private key file]
[enter Vcenter Administrator Credentials]
[IP/DNS]
[Required]
[Username]
[Required]
[Password]
[Required]
[Access Level]
[None]
[Use sudo with credentials entered above]
[Enter Root user credentials to update components]
[Username]
[Required]
[Password]
[Required]
[Use Credentials Above]
[Enter Administrator Credentials]
[Username]
[Required]
[Password]
[Required]
[Credentials]
[iLO CM Administrator Credentials]
[Username]
[Required]
[Password]
[Required]
[Enter switch credentials (Required only if switch firmware is to be updated)]
[Switch Credentials]
[Credentials are not set for the switch]
[Password Authentication(Applies to XGc only)]
[Full Authentication]
[Username]
[Required]
[Username not required]
[Password]
[Password not required]
[Enable Password]
[Enable Password not required]
[Credentials are the same on both switches]
[Switch B Credentials]
[Credentials are not set for the switch B]
[Password Authentication(Applies to XGc only)]
[Full Authentication]
[Username]
[Required]
[Username not required]
[Password]
[Password not required]
[Enable Password]
[Enable Password not required]
[Search is in progress. Please wait...]
[Nodes will be populated after search.]