﻿getresults


 
Enables you to get the results for any command executed. You can specify particular nodes. If you do not specify any nodes or baselines, the command uses the set currently selected in the session. 

Syntax 

smartupdate getresults [--nodes [nodelist]][--baselines [baselinelist]] 

Parameters 
 --nodes (n) [nodelist]  
A list of node IDs on which to perform the getresults command. 
--baselines(b) [baselinelist]  
The baselines to query for results. If you do not provide a list of baselines, all baselines in the session are used. 

Windows usage 

C:\> smartupdate getresults /nodes t1 t2 

T1 - 15 succeeded, 0 failed 

Comp1 - success. 

T2 - 0 succeeded, 0 failed 

Linux usage 

$ ./smartupdate getresults --nodes t1 

T1 - 15 succeeded, 0 failed 

Comp1 - success. 

Comp2 success. 
Return codes SUCCESS_NO_REBOOT  
Windows: 0 

Linux: 0 

Text: The command was successful. 
SUCCESS_REBOOT  
Windows: 1 

Linux: 1 

Text: The command was successful but a reboot is required. 
SUCCESS_NOT_REQUIRED  
Windows: 3 

Linux: 3 

Text: The command completed successfully, but was not required or everything is already current. 
FAILURE_GENERAL  
Windows: -1 

Linux: 255 

Text: A general failure occurred. For details, see the logs. 
FAILURE_BAD_PARM  
Windows: -2 

Linux: 254 

Text: A bad input parameter was encountered. For details, see the logs. 
FAILURE_COMPONENT_FAILED  
Windows: -3 

Linux: 253 

Text: The installation of the component failed. 
FAILURE_COMMAND_FAILED  
Windows: -4 

Linux: 252 

Text: The command failed. For details, see the logs. 
